What an in-line spreading & cutting line is
An in-line line connects the X6 automatic fabric spreading machine and the XC60 CNC cutting machine into one continuous flow: the spreader lays even, tension-free plies, then the cutter cuts by computer control in a single pass — no manual carry of fabric between stations, no waiting. One operator can supervise the whole cell.
Standard configuration: 1 spreader + 1 cutter
Most workshops start here. The X6 (max roll 500 mm, 150 kg, up to 100 m/min, four Housine servo motors) feeds layered fabric to one XC60 contour cutter (Housine servo platform; Fuji + Housine + DongWei combination available per request). This already removes the two slowest manual steps — laying and cutting — from the floor.
Scale to 1-to-2, 1-to-3, 1-to-4
When one cutter cannot keep up with spreading, add spreaders so several X6 units feed a single XC60: 1-to-2, 1-to-3 or 1-to-4. The cutter is never starved of material, and you avoid buying a second cutter you do not need. We size the ratio from your daily output and lay height.
Why run spreader and cutter as one line
- One continuous flow — no manual fabric carry between stations
- Tight, repeatable tolerances batch after batch, less fabric waste
- Fewer operators per table; easier to plan and track output
- Add spreaders before a second cutter when scaling — lower cost per meter cut
Why JUBMW
- Since 2012 — 2,000+ garment-factory customers served, the large majority in China, with JUBMW machines now running in six export markets
- English & Chinese support, with installation, remote or on-site training and spare-part supply
- Mature servo platforms — stable on the floor, low maintenance, easy to service
FAQ
Can I start with just one machine?
Yes. Many customers start with one X6 or one XC60 and add the second later; the line is designed to connect when you are ready.
When should I add a second spreader instead of a second cutter?
When the cutter waits for material. Adding spreaders (1-to-2 / 1-to-3 / 1-to-4) keeps one cutter fed and is cheaper than a second cutter.
What floor space does the line need?
It depends on spreader count and lay length. Send us your layout and we return a footprint drawing.
What training is included?
Factory commissioning plus remote or on-site training for your operators and maintenance staff, with spare parts available afterward.
Request a quote
Tell us your fabric types, daily output and lay height — we size the line ratio and return a quote. Contact JUBMW or message us on WhatsApp / TikTok.